I cant comment on any threads.....

Deleting your cookies and history normally sorts it out.

testing testing

cheers kenbo

Hiya

Kenners check out this priceworker

https://www.youtube.com/watch?v=no5SNlDLzdo

goyst

I couldnt watch after he started wi the grinder!!

You teach him all he knows goysty ?

I saw it five minutes ago. What a clown!!

He never hurt himself scary just so fooking slow

Care to educate the uneducated of us as to how it should have been done lads ??

Usually done with a cold chisel accompanied by a couple of cracks with a lump hammer, i believe

could be wrong...im not a bricky

And here's me thinking it had to do with the angle of dangle

goyst or kenbo will put us reyt

The line marks the angle that the brick needs cutting at. You hold your brick against the line and mark it with a pen/pencil. There's no need for a tape measure and bevel. That'll just slow you down loads.

i put a 10mm weep hole under it and against the perp, mark the brick cut it lay it.

That was like waching a snail this is me and kenners

https://www.youtube.com/watch?v=v0YSpyh6kcg

48p a time better than in running innit

Can u not send stevie the same virus shut him up

I just leave a 10/15mm gap, then mark it. When the apprentice first started marking up I use to get him to use one weephole against the perp.

Gobbledeegook to most on here!

I thought a weep hole was at the end of ya willy

... i thought it was under marts nose. !!   

Ain't they strange this lot

I wonder what they'd make of cavity trays?

Agh that depends on if you get the angle of the dangle right and turn them up150 mm past the lintles

Finger been in cavity tray ???


[   This image is no longer available.   ]